How to Use a Router

When doing carpentry works on furnishings people need wood routers. Routers are for precision cutting, especially where angles, curves, and detailed designs are concerned. Here are tips on how to use a router effectively and safely.

Things Needed

On how to use a router safely, the following things are needed: dependable working gloves, a dust mask, safety eye goggles, different router bits, and of course, a router. Carpentry works on furnishings, like making a bookshelf, also need to be measured well so they can be cut accordingly with a router.

Routing Reminders

Never use unsharpened router bits. Before doing the work, make sure to have them all sharpened first. This is a basic procedure on how to use a router. Some local hardware stores offer this service at a minimal fee. Better yet, buy brand new bits if the ones available at hand are overused. Aside from making the routing job more difficult, dull bits can be dangerous, especially with curving strokes when doing carpentry works on furnishings.

Another thing to remember is, always make sure that materials to be used is clamped securely to avoid unnecessary movements.

Always Have Something to Support It With

Clamp a quality wood piece that is of the same depth or thickness as that of the piece on the work bench. This serves as a support for the router to keep it or the piece to be worked on from wobbling or any such unnecessary movement. Wobbling, shaking, or vibrating may ruin the whole project. Everything depends on how to use a router properly.

How to Feed the Router

When feeding it into a material, always go from left to right. This ensures that the edge of the router for cutting gets in contact with the wood to be cut first, and not anything else. Always be guided with this way of how to use a router in terms of motion direction.

Cut Gradually

Do not use it with just a single stroke. Make a succession of shallow passes until the cut is deep enough. Then extend the bit gradually for deeper cuts. Making a deep cut with a single stroke can ruin the work, burn it, or even twirl the tool in one’s hands. Haphazardness in how to use a router can be hazardous. Carpentry works on furnishings takes patience to do.

Just Let it Do Its Work

Do not try to force or push it to cut in a fast manner. Forcing it this way slows down the motor and the cutting motion. Operating it haphazardly can result to splinters and chips on the surface of the wood, as well as burns. It would be a good idea to guide the router by using an edge guide, though.

Not Just an Edge Tool

One may also start cutting elsewhere on a wood aside from the edges. If the design calls cutting on the center of a wooden board, a router may also be thus used.

VN:F [1.9.22_1171]
Rating: 0.0/10 (0 votes cast)
Both comments and pings are currently closed.

Comments are closed.